A Serrurier truss is used in telescope tube assembly construction. The design was created in 1935 by engineer Mark U. Serrurier when he was working on the Mount Palomar 200 in (5.1 m) Hale Telescope.[1] The design solves the problem of truss flexing by supporting the primary objective mirror and the secondary mirror by two sets of opposing trusses before and after the declination pivot. The trusses are designed to have an equal amount of flexure, which allows the optics to stay on a common optical axis. When flexing, the "top" truss resists tension and the "bottom" truss resists compression. This has the effect of keeping the optical elements parallel to each other. The net result is all of the optical elements stay in collimation regardless of the orientation of the telescope.

A Serrurier truss tube assembly on the Carl Zeiss Cassegrain telescope in Ostrowik near Warsaw.

Some Serrurier truss designs end the truss members with a short flexible rod creating a more ideal "parallel motion flexure" system, to allow maximum parallelism of optical elements under gravitational load. Since truss members work primarily in tension and compression, there is no appreciable loss of stiffness due to the bending of the end flexures.[citation needed]

Principle of operation of a Serrurier truss for a telescope compared to a simple truss. For clarity, only the top and bottom structural elements are shown. Red and green lines denote elements under tension and compression, respectively.

Certain designs used by amateur telescope makers, specifically truss tube Dobsonians that use a single truss, are sometimes called "Serrurier truss" designs. These single truss designs are used for their rigidity and do perform the function of keeping the optical elements parallel, but since they lack the opposing truss that keeps optics on the same optical axis they are not technically "Serrurier trusses".

Other examples of Serrurier truss designs:

See also

edit

Footnotes

edit
  1. ^ Encyclopedia of Astronomy and Physics, "Reflecting Telescopes", Paul Murdin and Patrick Moore

References

edit
  • Learner, Richard. "The Legacy of the 200-inch", Sky&Telescope, April 1986, pp. 349–353
  • Diffrient, Roy. "Flexure of a Serrurier Truss", Sky&Telescope, February 1994, pp. 91–94
  • astro.caltech.edu - Reflecting Telescopes