The AB 250-3 (Abwurfbehälter) was an anti-personnel cluster bomb used by the Luftwaffe during World War II.

AB 250-3
TypeCluster bomb
Place of origin Nazi Germany
Service history
Used byLuftwaffe
WarsWorld War II
Specifications
Mass250 kg (550 lb)
Length1.63 m (5 ft 4 in)
Diameter38 cm (1 ft 3 in)[1]

Warhead108 x SD 2 anti-personnel bombs

AB 250-3

edit

The AB 250-3 could be suspended horizontally within a bomb bay or fuselage or wing hardpoint. It also had trunnions so it could be dropped by dive bombers. The body of the AB 250-3 was constructed of mild sheet steel and was of clamshell construction and hinged at the tail. It was divided into three compartments; a dome-shaped nose compartment, a cylindrical center compartment, and a cone-shaped tail compartment. The AB 250-3 could carry 108 x SD 2 anti-personnel bombs in its center section. The AB 250-3 was similar to the other AB 250 containers except it had six tail fins instead of four welded to the container with braces riveted between each fin. The nose compartment housed the fuze pocket which was welded to a bracket on the upper half of the container. The two halves were held together by a shear wire which passed through a steel anvil, in the lower part of the fuze pocket. When dropped a time fuze was triggered and after a few seconds, the wire holding the container together was sheared by a small exploder under the fuze. The case then opened and allowed the bombs to fall out. The containers were painted dark green with two longitudinal red stripes on tail cone.[1]

edit

See also

edit

References

edit
  1. ^ a b United States War Office (1953). German explosive ordnance : (bombs, fuzes, rockets, land mines, grenades and igniters). United States Government Printing Office. OCLC 713755660.